Need some help figuring out your bends? More metal in the scrap pile than in your car? STOP THE MADNESS!! Bend-Tech EZ This new software is the 2D version of the Bend Tech EZ 3D , but don't be fooled, it can run with the Big Dogs.

Bend-Tech EZ is an entry level tube bending software for the home hobbyist. If your parts are simple 2D parts (parts that lay flat when completed) then EZ will most likely do the trick. EZ provides dozens of predefined templates and has a custom part interface which allows for up to 6 bends. Additional templates are available from download.

 RETAIL $129.00
Our Price: $69.00

Are you looking for a SIMPLE yet powerful piece of software to aid in the design of your project.  Look no farther BEND TECH 3D is what you are looking for.  It is similar to the 2D version except it is in 3D.

Bend-Tech EZ3D was designed to help out the serious hobbyist. We took our easy to use EZ product and added a 3D interface. Our Tri-Star interface is unique in that a customer doesn't need to learn XYZ, it uses terms like front, back, floor, ceiling, left and right.

While you are stepping quickly around the part, EZ3D is calculating your bend angles and rotations. No more guessing. As mentioned previously, the EZ3D functions are also available in PRO and SE. EZ3D is also our introduction to Bend-Tech's simulation.

RETAIL $279.00
Our Price: $149.00
 

Finally a program to design your COMPLETE job that DOES NOT COST THOUSANDS of DOLLARS. 

This program handles everything from one simple bend to building your whole project. Once you have designed your project, it will detail each bar so you can create each individual piece and show you the angle and degree to notch it at.  Rotate 360 degrees to view from any angle

RETAIL $599.00
Our Price: $275.00